Cut a hole the size of a receptacle for your speaker system( 2×3″) where you want the leads for the equipment. Then reach into the wall for the fish tape. If you wrap white tape on the end of the fish tape it will be more visible. Attach a draw string to the end of the fish tape and then attach the cables or wires as needed. Use a knife to cut the insulation to find the tape.

As long as the holes match up close enough you can use a thick stiff copper wire and run it down into the hole from the wall raising it up and down gently moving it left and right until you feel it go through the hole, then tie a strong string on it pulling it through the hole. strong copper wire most of the time will go through installation. This has worked out great for most of my projects throughout my years.

Try to push the fishtape at an angle so it will “ride up” the inside surface of the drywall. Insulation will be hard to get through and may divert the tape.

just bash a few holes in the wall then when you have finished my dad will plaster the wall 4 you at a small fee hahaha?????